Friday, September 17, 2010

My computer monitor have gray lines running across, same article when i conversion monitors - what's the problem?



Answer:

sort sure your video card is connected securely to the rgb cable. it could be that your video card is fruitless.
could be a problem with your video card
Maybe within is a problem with the cord or video card.
Possibly increase galvanize rate. Right clickk on desktop, properties, settings, advanced, monitor. refresh frequence wishes to be increased
Try checking the monitor cable. If it has a bent pin the monitor will look funny and the cable should be replaced. If that's not it check the illustrative card.
cud b having problem next to your video card or possible that the line voltage isn't correct.check out Ur UPS.
I have that same problem. Best Buy Geek Squad gave me to answers to that.



One: Clean the port where on earth you plug you monitor in both on the harddrive and the plug from the monitor next to a Q-Tip and A VERY SMALL AMOUNT OF PINE-SOL



Two: Buy a new monitor







The frist one worked beside my computer so you shouldn't have to buy a tentative one. If you do sorry if I wasn't much help.



Good Luck!!
Sounds resembling the video card, assuming you got alike results on both monitors, Try changing the resolution and\or adapter renew rate under "display" contained by the "control panel" you may need to do this within safe mode. Then if needed, I would re-install the video drivers. If that does not work, enlarge computer case and verbs out video card and reinsert it, it may just not take a seat correctly. Try new video card as later results. Good Luck, Dan

No comments:

Post a Comment