Trinitron monitor go into power save mode by itself...sez to reset via the notebook? How do I do this...How can I prevent this? thank you
Answer:
If you fiddle near SETUP in the display of some RAM paragraph, these sort of things happen. I may be wrong, but I presume this could be one of the reason.
If you are technical, approachable the PC, remove the battery, discharge the CMOS, (your booklet will show you how) if necessary, by resetting the jumper. This should mostly resolve. Then go into SETUP when the system boots and choose 'Load System Defaults'.
These steps usually work
How did you type your press?
also might want to check the power management contained by the bios of the computer. read up on your computer manual because adjectives computers are different on how to enter setup.
No comments:
Post a Comment